Product Description


Thermal Shock Test Chamber is used to test the bearing extent of the material structures and composite material in an instant and continuous high temperature and extremely low temperature environment, which is in the shortest time to test its thermal expansion and contraction caused by chemical change or physical harm.
 

Product Info

Unit USD
Minorder 1
Supplyability 30 Set/Sets per Month
Port shenzhen
Certification ISO,CE
Place DongGuang,China
Packaging Each set protected by resin fiber and PP film, then put into Strong wooden case with operation manual and vedio inside.

Product Detail


Application

Thermal Shock Test Chamber is used to test the bearing extent of the material structures and composite material in an instant and continuous high temperature and extremely low temperature environment, which is in the shortest time to test its thermal expansion and contraction caused by chemical change or physical harm.


Main Parameters

 
Model HD-E703-1600 (Two Zone)
Basket internal dimension (W*D*H) 1300*1200*1000mm
External dimension(W*D*H) 4000*2000*1900mm
Test method High and Low Temp. Chamber (Two zone, basket type)
Thermal recovery time Within 5 minutes
Lifting switch time 7~20seconds
Low Temp. Test range -10 to -40℃
Pre-cool Temp. zone Lowest temp. is -55℃
High Temp. Test range +60 to +150℃
Pre-heat Temp. zone Highest Temp. is +170℃
Temperature fluctuation ±1℃
Test hole for cable routing Diameter 100mm on the left of chamber attach a silicone plug
External chamber material High quality electrolytic steel plate spray with powder, anti-rust
Internal material SUS#304 stainless steel
Thermal insulation material High quality superfine glass fiber
Refrigerant R404A / R23
Cooling method Water cooling
Power supply Three phase, 380V, 50Hz
Power 120KW
Current 160A


High temperature chamber:

1, Including three parts: heater, draught fan and air duct valve
2, Draught fan cyclically stirs hot air through heater
3, The basket with testing product drive to high temperature range when doing high temp. impact test.


Low temperature chamber:

1, Including four parts: evaporator, energy storage piece, draught fan and air duct valve
2, Draught fan cyclically stirs cold air through evaporator and energy storage piece.
3, The basket with testing product drive to low temperature range when doing low temp. impact test.


Drive device:

Pneumatic cylinder: drive basket with testing product to high and low temperature chamber
Air compressor: Provide the compressed air for driving pneumatic door (supplied by buyer)


Refrigerating device:

Cooling system: complex overlapping efficient cryogenic loop system
Compressor: France Tecumseh compressor
Refrigerant: Environmental protection refrigerant R23/R404A
Condensation: Stainless steel welded plate heat exchanger


Safety device:

Power overload protection                                 
Leakage protection
Control circuit overload protection
Short-circuit protection
Compressor overload protection
Ground protection
Over temperature protection
Audible and visual alarm


Cooling Compressors

Products Categorys

Recommend Products

Navigation