Product Description

Ventilation Type Aging Test Chamber used to test the material characteristic for wire type, skin type, plastic, rubber, cloth, Equipped with a special ventilation regulator for maintain the fresh air inside when heating. 

 

 

Product Info

Minorder 1
Payment L/C,Western Union,D/P,D/A,T/T,MoneyGram,cash or escrow
Place Guangdong,China
Packaging Each set protected by resin fiber and PP film, then put into Strong wooden case with operation manual and vedio inside.

Product Detail

Ventilation Type Aging Test Chamber

 

Product Description

Ventilation Type Aging Test Chamber design with sophisticated air-displacement adjustment device and a digital voltage meter, current meter, watt-hours, the timer can be used to measure the air replacement rate. Horizontal circulatory air supply system and both sides of airflow regulator to ensure the internal temperature uniformity and stability.The forced-convection laboratory oven is used for thermal endurance evaluation of electrical insulating materials.



Standard parameters
 

Item Specification
Internal dimension (WxDxH) 500*400*500mm
External dimension (WxDxH) 1050*900*1400mm
Internal material SUS# 304 Stainless steel
Temperature range Room temperature +10 ~ 300℃
Temperature fluctuation ± 1℃
Controller LED display, PID Temperature Control & Timing Device, with Audible and
visual alarm
Time setting 1~ 999min
Air forced conversion 0-30 cycles/hour
Conversion time setting 1min~99hours
Turntable for sample Diameter 300mm
Insulation material High density silicate insulation fiber and high temperature resistant sealer
Protection device Over Temperature Protection,
Heater Short Circuit,
Motor Overheating & Leakage,
Earth leakage protection
Power Single-phase, 220V±10%, 50Hz


 

Corresponding standard

Accord with ASTM D5423-9(R2005)(Ⅱ-Type oven)and ASTMD 5374-93(2005) UL-1581,VDE,JIS,IEC



Quality assurance

1. The guarantee period with FOC within 1 year (not including expendable parts cost and transport & travel fees)
1.1 During the guarantee period, Haida shall supply free maintenance or replacement for the damaged part (just for non-expendable part) caused by non-human reasons;
1.2 If any quality problems occur within the guarantee period, and Haida must provide on-site service, the transport and travel expense shall be borne by buyer;
1.3 If any big quality problems occurs out of the guarantee period, Haida will provide a maintain service, the transport and travel expense shall be borne by buyer, also charge for a favorable price for new parts;
1.4 Haida will provide a lifetime favorable price to the buyer for expendable & non-expendable parts used in system operation, equipment maintenance;


2. The following conditions need to be paid reasonably even in the guarantee period:
2.1 Natural disaster
2.2 Operating mistakes
2.3 Voltage is not fit for our manual
2.4 Uninstall without our guides
2.5 Damaged for borrowing to others
2.6 Damaged for without authorized machine modification
2.7 Damaged for without authorized calibration
2.8 Without authorized transshipment mistake

 

Products Categorys

Recommend Products

Navigation